How to set up the Subal ND30 – Part two – Strobes

As promised this is the long overdue second section about how I personally set up my Subal ND30 (underwater housing for the Nikon D300). I have two Inon Z-240 type 3 strobes and sea-and-sea sync cords. This is how I put mine together. Other makes might be different so you should ask the advice of your dealer. Remember I’m still just a beginner and these instructions are mostly my aid-memoir.

Strobe sync cords.

To connect the strobe to the housing you need a strobe sync cord (or two). I have two different ones depending on if I’m using one strobe or two, but essentially they have the same method to attach.

The small end goes in the camera and the big end into the strobe.

Attaching the sync cord to the camera housing:

1) Take the plastic cover off the small end (and keep it handy)

2) Put the metal ring back on flat side first (I learned the hard way not he leave these metal rings on for storage, mine got salted on and took 3 burly men and a wrench to get it off again).

3) Grease the little blue oring

4) Take the stopper out from one of the flash ports on the housing.

5) The pins go in a certain pattern inside the port and the sync cord so line it up by twisting until it drops into place them push in firmly.

6) Screw the back part of the sync cord (not the metal ring) to tighten

7) Now screw the metal ring for extra tightness.

8) Take the plastic cover and port cover and screw together so they protect each other and stow somewhere safe and out of the way.

Attaching the sync cord to the strobe(s):

1) Take the plastic cover off the large end (and keep it handy)

2) Grease the little blue oring

3) Take the little plastic cover from the sync port on the strobe

4) Line up the little pins and holes in the sync cord and port (mine has a little yellow dot to line up too)

5) Once its dropped into place push down firmly and screw into place.

6) Screw the two little plastic covers together so they protect each other and stow somewhere safe.

I have one single cord for a single strobe and one splitter cord for two strobes so I only ever use one port on my housing. Don’t make the same expensive mistake I made, make sure you grease the orings on the port stopper for the unused port because if the water gets in your port will go rusty and need replacing! If you use two single sync cords I guess you wouldn’t get this problem anyway. When my port when rusty the first I knew about it was when my strobes were behaving very erratically, they were firing seemingly at random and wouldn’t stop for a while after I pressed the shutter, this didn’t happen during my test shots in the hotel, it happened on the dive because the housing was wet and the cord was shorting. I thought my camera was broken! Luckily it all went back to normal after we unplugged the affected strobe port from the little circuit board inside the housing.

See the original post for instructions on how to put together the main subal housing back and 60mm lens port and tokina 10-17 fisheye port.

see part three coming soon for 105VR lens…

Advertisements

One thought on “How to set up the Subal ND30 – Part two – Strobes

  1. Pingback: How to set up a Subal ND30 – Part three – 105 VR lens « Memoirs of an Underwater Photographer

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s